Calculating Wormhole Propagation and Skin Factor in Carbonate Reservoirs during Directional Wells Acidizing

Document Type : Research Paper

Authors

Chemical and Petroleum Engineering Department, Sharif University of Technology, Tehran, Iran

Abstract

Matrix acidizing is a method for improving well inflow performance. In this operation, acidic solution is injected into the carbonate formation to increase near wellbore permeability by rapid creation of irregularly shaped channels named “wormholes”. Other common carbonate stimulation techniques include: hydraulic fracturing, acid fracturing, hydro-blasting and combination of acidizing and cased-hole perforation. In this research, we aim to calculate wormhole propagation in a horizontal carbonate later (bed dip=0) during acidizing a directionally drilled well which is open-hole or cased-hole and thus modeling skin factor evolution with time. For this purpose, Buijse-Glasbergen semi-empirical field scale wormhole propagation model based on regression with acid efficiency curve, a model for unsteady-state pressure distribution in the formation caused by a directionally drilled well and a model for single phase Newtonian fluid flow in the wellbore considering inflow/outflow from wellbore wall are coupled which by solving them simultaneously, wormhole propagation in each time step can be calculated. Based on the obtained results, wormhole propagation decreases with reservoir layer depth due to the fact that by starting acidizing job, permeability of the upper portions of the layer will increase more than the lower parts as a result of the sooner contact of the acid with them. Thus, these parts will receive larger volumes of acid and greater wormhole penetration depths. Also, wormhole propagation radius will be increased in a cased-hole completion in comparison with the open-hole and thus  carbonate reservoirs acidizing results will be improved. It is required to consider optimum number of sublayers used in simulation based on reasonable precision and runtime to obtain accurate results. Increasing wellbore inclination causes wormhole propagation to be increased to a specific depth, but it does not necessarily improve overall acidizing results and reducing skin factor. Minimum skin factor occurs in a specific inclination which must be considered in planning directional wells which their reservoirs will require acidizing certainly.
 

Keywords

References

[1]. Teimouri A, Sadeghnejad S, Saeedi Dehaghani A H (2020) Experimental investigation of acid injection on fracture opening in calcite and dolomite reservoirs, Journal of Petroleum Research, 30, 99-2: 3-13. ##
[2]. Al Jawad M S H (2018) Development of a fully integrated acid fracture model (Doctoral dissertation).
[3]. Guo B (2015) Petroleum production engineering, a computer-assisted approach, Elsevier. ##
[4]. Schön J H (2015) Physical properties of rocks: Fundamentals and principles of petrophysics, Elsevier. ##
[5]. Wu Y, Kou J, Sun S, Wu Y S (2021) Thermodynamically consistent Darcy–Brinkman–Forchheimer framework in matrix acidization, Oil and Gas Science and Technology–Revue d’IFP Energies Nouvelles, 76: 8. ##
[6]. Sheikhi Bojani F, Ramezanzadeh A, Lotfi M (2021) Determining the appropriae rate of acid injection in carbonate formations to increase permeability, Journal of Petroleum Research, 31, 117: 124-145. ##
[7]. Economides M, Nolte K (1989) Reservoir stimulation: Schlumberger Educational Services, Houston, TX. ##
[8]. Crowe C, Masmonteil J, Thomas R (1992) Trends in matrix acidizing, Oilfield Review, 4, 4: 24-40. ##
[9]. NazariSaram M, Moradi M H (2021) Simulation of weak and strong acids injection into a carbonate formation: case study of acidizing in two hydrocarbon layers of an oil field, South-West of Iran, Journal of Petroleum Research, 31, 1400-5: 114-126. ##
[10]. Buijse M A, Glasbergen G (2005) A semi-empirical model to calculate wormhole growth in carbonate acidizing, in SPE Annual Technical Conference and Exhibition, Society of Petroleum Engineers. ##
[11]. Aldhayee K, Ali M T, Nasr-El-Din H A (2018) Acid wormholing in multistage acid fractured wells completed in tight naturally fractured dolomite formation: benefits and impacts on acid fracturing stimulation design, in SPE International Hydraulic Fracturing Technology Conference and Exhibition, OnePetro. ##
[12]. Schwalbert M P, Zhu D, Hill A D (2019) Anisotropic-wormhole-network generation in carbonate acidizing and wormhole-model analysis through averaged-continuum simulations, SPE Production and Operations, 34, 01: 90-108. ##
[13]. Hosseinzadeh B, Ayatollahi S, Rostami B, Bazargan M (2018) Modeling the Impact of diverting agents on acidization of heterogeneous carbonate reservoir based on radial system, Journal of Petroleum Research, 28, 97-5: 4-14. ##
[14]. Akanni O, Nasr-El-Din H (2015) The accuracy of carbonate matrix-acidizing models in predicting optimum injection and wormhole propagation rates, in SPE Middle East Oil and Gas Show and Conference, OnePetro. ##
[15]. Daccord G, Lietard O, Lenormand R (1993) Chemical dissolution of a porous medium by a reactive fluid—II. Convection vs reaction, behavior diagram, Chemical Engineering Science, 48, 1: 179-186. ##
[16]. Fredd C, Tjia R, Fogler H (1997) The existence of an optimum damkohler number for matrix stimulation of carbonate formations, in SPE European Formation Damage Conference, OnePetro. ##
[17]. Furui K, Burton R C, Burkhead D W, Abdelmalek N A, Hill A D, Zhu D, Nozaki M (2012) A Comprehensive model of high-rate matrix-acid stimulation for long horizontal wells in carbonate reservoirs: Part I—scaling up core-level acid wormholing to field treatments, SPE Journal, 17, 01: 271-279. ##
[18]. Glasbergen G, Kalia N, Talbot M S (2009) The optimum injection rate for wormhole propagation: myth or reality?, in 8th European Formation Damage Conference, OnePetro. ##
[19]. Williams B, Gidley J, Schecter R (1979) Acidizing Fundamentals, Monograph Volume 6, SPE-AIME Henry L. Doherty Series, Dallas, 16-17. ##
[20]. Behenna F (1994) Interpretation of matrix acidizing treatments using a continuously monitored skin factor, in SPE Formation Damage Control Symposium, Society of Petroleum Engineers. ##
[21]. Montgomery C, Jan Y M, Niemeyer B (1995) Development of a matrix acidizing stimulation treatment evaluation and recording system (MASTERS). SPE Production and Facilities, 10, 04: 219-224. ##
[22]. Prouvost L P, Economides M J (1987) Real-time evaluation of matrix acidizing treatments, Journal of Petroleum Science and Engineering, 1, 2: 145-154. ##
[23]. Horner D R (1951) Pressure build-up in wells, in 3rd World Petroleum Congress, World Petroleum Congress. ##
[24]. Matthews C, Brons F, Hazebroek P (1954) A method for determination of average pressure in a bounded reservoir, Transactions of the AIME, 201, 01: 182-191. ##
[25]. Kochina P (1949) Theory of ground water movement, 1962. ##
[26]. Van Everdingen A, Hurst W (1949) The application of the Laplace transformation to flow problems in reservoirs, Journal of Petroleum Technology, 1, 12: 305-324. ##
[27]. Cinco H, Miller F, Ramey H (1975) Unsteady-state pressure distribution created by a directionally drilled well, Journal of Petroleum Technology, 27, 11: 1392-1400. ##
[28]. Fattahi H (2018) An estimation of required rotational torque to operate horizontal directional drilling using rock engineering systems, Journal of Petroleum Science and Technology, 8, 1: 82-96. ##
[29]. Carden R S, Grace R D (1998) Horizontal and directional drilling, Tulsa, Oklahoma, 2007. ##
[30]. Liangbiao O, Sepehr A, Khalid A (1998) A single-phase wellbore-flow model for horizontal, vertical and slanted wells, SPE Journal, 3, 02: 124-133. ##
 
[31]. Schlichting H (1987) Boundary layer theory (seventh english edition), New York, McGraw-Hill Book Co. ##
[32]. Matthews C S, Russell D G (1967) Pressure buildup and flow tests in wells, 1: Henry L. Doherty Memorial Fund of AIME. ##
[33]. Ley H C (1974) Unsteady-state pressure distributions created by a slanted well, or a well with an Inclined Fracture, Stanford University. ##
[34]. Ouyang L B, Arbabi S, Aziz K (1997) General single phase wellbore flow model. No. DOE/BC/14862-T1. Stanford Univ., CA (United States). Dept. of Petroleum Engineering. ##
[35]. Ouyang L B, Aziz K (1996) Steady-state gas flow in pipes, Journal of Petroleum Science and Engineering, 14, 3-4: 13, 7-158. ##
[36]. Gregory G A, Fogarasi M (1985) Alternate to standard friction factor equation, Oil and gas journal, 83, 13: 120-127. ##
[37]. Cheng H, Schwalbert M P, Hill A D, Zhu D (2019) A fundamental model for wormhole formation including multiphase flow, in 11th International Petroleum Technology Conference, European Association of Geoscientists and Engineers. ##
[38]. Daccord G, Touboul E, Lenormand R (1989) Carbonate acidizing: toward a quantitative model of the wormholing phenomenon, SPE Production Engineering, 4, 01: 63-68. ##
[39]. Fredd C (2000) Dynamic model of wormhole formation demonstrates conditions for effective skin reduction during carbonate matrix acidizing, in SPE Permian Basin Oil and Gas Recovery Conference, Society of Petroleum Engineers. ##
[40]. Mahmoodi A, Javadi A, Sola B S (2018) Porous media acidizing simulation: New two-phase two-scale continuum modeling approach, Journal of Petroleum Science and Engineering, 166: 679-692. ##
[41]. Panga M K, Balakotaiah V, Ziauddin M (2002) Modeling, simulation and comparison of models for wormhole formation during matrix stimulation of carbonates, in SPE Annual Technical Conference and Exhibition, Society of Petroleum Engineers. ##
[42]. You J, Lee K J (2020) Analyzing the dynamics of mineral dissolution during acid fracturing by pore–scale modeling of acid–rock interaction, in SPE Improved Oil Recovery Conference, OnePetro. ##
[43]. Glasbergen G, Glasbergen G (2005) Field validation of acidizing wormhole models, in SPE European Formation Damage Conference, Society of Petroleum Engineers. ##
[44]. Nitters G, Roodhart L, Jongma H, Yeager V, Buijse M, Fulton D, Jantz E (2000) Structured approach to advanced candidate selection and treatment design of stimulation treatments, in SPE Annual Technical Conference and Exhibition, Society of Petroleum Engineers. ##
[45]. Khamehchi E, Tabasy M, Dashtakipour S (2016) An Experimental investigation of the effect of magnetic acid injection for increasing carbonate core permeability and comparison with regular acid, Journal of Petroleum Research, 25, 85-1: 128-141. ##
[46]. Karakas M, Tariq S M (1991) Semianalytical productivity models for perforated completions, SPE Production Engineering, 6, 01: 73-82. ##
 
 
Journal of Petroleum Research
Volume 32, 1401-1 - Serial Number 122
May and June 2022
Pages 64-80

Files

Share

How to cite

Statistics