بررسی آزمایشگاهی پایداری آسفالتین در تزریق آب ‌کم‌شور با استفاده از سامانه دیداری هله-شاو

نوع مقاله : مقاله پژوهشی

نویسندگان

1 دانشگاه صنعتی شریف

2 استاد تمام دانشکده مهندسی شیمی و نفت، مدیر پژوهشکده بالادستی نفت

3 دانشکده مهندسی شیمی و نفت دانشگاه صنعتی شریف

10.22078/pr.2024.5254.3331

چکیده

‌‌‌‌‌تزریق آب کم‌شور یا مهندسی‌شده به مخازن نفتی به‌عنوان یکی از کاربردی‌ترین روش‌های حفظ فشار مخزن و افزایش برداشت نفت، شناخته می‌شود. با این‌وجود یکی از جنبه هایی که نیاز به بررسی بیشتر دارد، اثر تغییر شوری آب بر ناپایداری و رسوب آسفالتین است که بسته به میزان آن می تواند منجر به آسیب سازند مخزن و کاهش تزریق‌پذیری شود. در این پژوهش جهت بررسی میزان آسیب ایجاد شده و مکانیزم‌های مرتبط، تست‌های آزمایشگاهی در سامانه هله-شاو به صورت تزریق همزمان آب و نفت انجام گرفت. تاثیر نوع آب در حضور عامل تحریک‌کننده آسفاتین (نرمال پنتان) و بدون آن و نوع نفت روی ناپایداری آسفالتین برای دو نمونه نفت خام میدان آب تیمور و کوپال بررسی شد. نتایج برای نفت آب تیمور با آب‌های مختلف نشان می‌دهد که نوع آب تاثیر بسزایی در رفتار سطح تماس آب-نفت ازجمله تشکیل امولسیون درجا و رسوب آسفالتین دارد. پایدارترین امولسیون با شعاع قطرات 151 میکرون در آب دریای دوبار رقیق‌شده و مقدار رسوب آسفالتین 3/18 درصد حجمی سل در حضور آلکان حاصل شد. نتایج نشان داد که رابطه‌ی مستقیمی بین پایداری امولسیون و میزان رسوب آسفالتین وجود دارد؛ به نحوی که هرچه امولسیون پایدارتری تشکیل شود، رسوب آسفالتین بیشتری نیز تشکیل می‌شود. نتایج آزمایش‌های تزریق همزمان نفت آب تیمور و کوپال با آب دریای ده‌بار رقیق‌شده نشان داد که نواحی در محیط سلول وجود داشتند که علیرغم عبور آب از کناره‌های آن‌ها، سطوح تماس نفت-آب همچنان حتی با افزایش نرخ تزریق بدون تغییر باقی ماندند. تصاویر میکروسکوپی حاکی از وجود یک لایه‌ی سخت، که مانع از نفوذ آب و جاروب قطره‌ی نفت می‌گردید، بود. این پدیده نشان می‌دهد در فرایند طبیعی تزریق آب کم‌شور در میادین در برخی شوریها امکان ناپایداری آسفالتین وجود دارد که ممکن است منجربه تله افتادن قطرات نفت در اثر سخت‌شدگی سطح سطح تماس آب-نفت شود.

کلیدواژه‌ها

موضوعات


عنوان مقاله [English]

Laboratory investigation of asphaltene stability in low-salinity waterflooding using a Hele-Shaw cell

نویسندگان [English]

  • Hassan Mahani 1
  • Shahab Ayatollahi 2
  • Fatemeh Ghorbanpoor 1
  • Mohammad Shahabi 3
1 Chemical and Petroleum Engineering, Sharif University of Technology
2 Department of Chemical and Petroleum Engineering Azadi St.
3 Department of Chemical and Petroleum Engineering, Sharif University of Technology
چکیده [English]

Low-salinity waterflooding is a practical method to maintain the pressure of reservoirs and increase oil recovery. However, an aspect that requires further investigation is the impact of water salinity on the instability and deposition of asphaltene in the reservoir that may lead to formation damage and injectivity loss. To investigate this type of damage and the associated mechanisms, laboratory tests were performed using a Hele-Shaw cell. Oil and water were co-injected to mimic the injection area condition around the well-bore, and the effect of brine salinity on emulsification and asphaltene precipitation/deposition was investigated. Two different scenarios were considered to localize the deposited asphaltene: i) in the presence of an asphaltene stimulator such as normal pentane, ii) in absence of normal pentane. Two compositionally different crude oils were used: Ab-Timur and Koupal. The results for Ab-Timur oil showed that the brine salinity and the type of ions have a significant effect on in-situ emulsification and asphaltene deposition. For this oil, the most stable emulsion with a droplet size of 151 microns was obtained in twice-diluted-seawater and the amount of asphaltene precipitation was 18.3% of the cell volume in the presence of normal alkane. It can be concluded that there is a direct relationship between emulsion stability and asphaltene precipitation: the more stable the emulsion, the more asphaltene deposition. For both oils, it was observed that with ten-times-diluted seawater there are trapped oil areas which are bypassed by the flowing water. Areal microscopic observation showed that the oil-water interface remains unchanged even by increasing injection rate, due to formation of a rigid layer around the oil. This shows that in the actual process of low-salinity waterflooding in oil fields, there is a possibility of asphaltene instability at some salinity ranges that can cause oil trapping due to oil-brine interface hardening.

کلیدواژه‌ها [English]

  • Enhanced oil recovery
  • Low-salinity water
  • Asphaltene Instability
  • Oil-water contact surface
  • Hele-Shaw cell
  • Emulsion