f7dc9c6ab1f8c7a 8fcd9532671845f 8fcd9532671845f

گوگردزدایی اکسایشی DBT با استفاده از نانوکاتالیست‌های سه فلزی Ni-Mo-W بر پایه زئولیت‌های طبیعی مختلف: موردنیت، فرریت و کلینوپتیلولیت

نوع مقاله: مقاله پژوهشی


1 دانشکده مهندسی شیمی، دانشگاه صنعتی سهند، تبریز، ایران

2 دانشکده مهندسی شیمی، دانشگاه کاشان، ایران



در این مقاله زئولیت‌های طبیعی کلینوپتیلولیت، فرریت و موردنیت پس از اصلاح به‌روش شیمیایی به‌عنوان پایه کاتالیست‌های NiMoW مورد استفاده قرار گرفتند و در گوگردزدایی اکسایشی یک سوخت مدل مورد آزمایش قرار گرفتند. کاتالیست‌های برپایه NiMoW، با استفاده از XRDا، EDXا، FESEM و FTIR تعیین مشخصات شدند. به‌جز برای کاتالیست NiMoW-Clin، دو کاتالیست دیگر پایه‌ای بی شکل دارند که تاثیر اصلاح شیمیایی را بر تغییر ساختار بلورین زئولیت طبیعی نشان می‌دهد. NiMoW-Ferr، دارای ذراتی کوچک با پراکندگی زیاد و برهم‌کنش قوی است. نسبت کمتر Si/Al در این نمونه توسط هر دو آنالیز FTIR و EDX تایید شد. در میان نانوکاتالیست‌های مطالعه شده، g 2/0 نانوکاتالیست NiMoW-Ferr توانست 8/92%دی بنزوتیوفن را در غلظت اولیه ppm 250 در دمای C°60 در مدت min 60 حذف کند. استخراج با استونیتریل پس از ODS سه مرتبه تکرار گردید و سبب افزایش حذف دی بنزوتیوفن شد. مطالعه برروی تاثیر غلظت DBT نشان داد مقادیر زیاد غلظت DBT موجب کاهش درصد گوگردزدایی اکسایشی می‌گردد.  همچنین افزایش مقدار کاتالیست پس از یک مقدار مشخص بر بازدهی گوگردزدایی اکسایشی تاثیری ندارد.


عنوان مقاله [English]

Oxidative Desulfurization of DBT Using Tri-metallic Ni-Mo-W Nanocatalysts Based on Different Natural Zeolites: Mordenite, Ferrierite, and Clinoptilolite

نویسندگان [English]

  • Somaiyeh Allahyari 1
  • Nader Rahemi 1
  • Milad Mehrabi 2
  • Saeed Tadayyon 1
1 Chemical Engineering Faculty, Sahand University of Technology, Tabriz, Iran
2 Chemical Engineering Faculty, Kashan University, Iran
چکیده [English]

In this paper, natural zeolites of clinoptilolite, ferrierite, and mordenite were chemically modified and used as support of NiMoW catalysts. The NiMoW based catalysts were characterized by XRD, FESEM, and FTIR. In all studied catalysts, according to XRD, NiO exists in small crystallites but XRD peaks attributed to MoO2, MoO3 or WO3 were not observed. FESEM indicted NiMoW-Ferr had small particles with high dispersion and strong interaction. Moreover, lower Si/Al ratio and higher population of metal oxides in NiMoW-Ferr nanocatalyst was confirmed by FTIR. Finally, among studied nanocatalysts, evaluation of synthesized samples in oxidative desulfurization of dibenzothiophene showed NiMoW-Ferr had supreme activity of 92.8% of dibenzothiophene removal in 250 ppm, 0.2 g of catalyst, 60 °C and 60 min reaction time.

کلیدواژه‌ها [English]

  • Oxidative Desulfurization
  • Ni-Mo-W
  • Nanocatalyst
  • Mordenite
  • Ferrierite
  • Clinoptilolite
[1]. Liu P., Rodriguez J. A., Asakura T., Gomes J. and Nakamura K. “Desulfurization reactions on Ni2P(001) and α-Mo2C(001) surfaces:  complex role of P and C sites,” J. Phys. Chem. B., Vol. 109, No.10, pp.4575-4583, 2005. ##

[2]. Mc Kinley S. G. and Angelici R. J. “Deep desulfurization by selective adsorption of dibenzothiophenes on Ag+/SBA-15 and Ag+/SiO2,” Chem. Comm., Vol. 20, pp. 2620-2621, 2003. ##

[3]. Wang F., Zhang Z., Yang J., Wang L., Lin Y. and Wei Y., “Immobilization of room temperature ionic liquid (RTIL) on silica gel for adsorption removal of thiophenic sulfur compounds from fuel,” Fuel, Vol. 107, pp. 394-399, 2013. ##

[4]. Ninh T. K. T., Laurenti D., Leclerc E. and Vrinat M., “Support effect for CoMoS and CoNiMoS hydrodesulfurization catalysts prepared by controlled method,” Appl. Catal., A, Vol. 487, pp. 210-218, 2014. ##

[5]. Trejo F., Rana M. S., Ancheyta J. and Chávez S. “Influence of support and supported phases on catalytic functionalities of hydrotreating catalysts,” Fuel, Vol. 138, pp.104-110, 2014. ##

[6]. Trejo F., Rana M. S., Ancheyta J. and Rueda A., “Hydrotreating catalysts on different supports and its acid–base properties,” Fuel, Vol.100, pp.163-172, 2012. ##

[7]. Shi Y., Zhang X. and Liu G. “Activated carbons derived from hydrothermally carbonized sucrose: remarkable adsorbents for adsorptive desulfurization,” ACS Sustainable Chemistry & Engineering, Vol. 3, No. 9, pp. 2237-2246, 2015. ##

[8]. Xiong J., Zhu W., Li H., Ding W., Chao Y., Wu P, Xun S., Zhang M. and Li H., “Few-layered graphene-like boron nitride induced a re markable adsorption capacity for dibenzothiophene in fuels,” Green Chemistry Journal, Vol.17, Issue 3, pp.1647-1656, 2015. ##

[9]. Jiang W., Zhu W., Li H., Wang X., Yin S., Chang Y. and L. Huaming, “Temperature-responsive ionic liquid ex traction and separation of the aromatic sulfur compounds,” Journal of Fuel, Vol. 140, pp. 590-596, 2015. ##

[10]. Balinge K. R., Khiratkar A. G., Krishnamurthy M., Patle D. S., K CK and Bhagat P. R. “Deep-desulfurization of the petroleum diesel using the heterogeneous carboxyl functionalized poly-ionic liquid,” Resource-Efficient Technologies, Vol. 2, Supplement 1, pp. S105-S113, 2015. ##

[11]. Kwak C., Lee J. J., Bae J. S., Choi K. and Moon SH. “Hydrodesulfurization of DBT, 4-MDBT, and 4,6-DMDBT on fluorinated CoMoS/Al2O3 catalysts,” Applied Catalysis A: General, Vol.200, No, 1-2, pp. 233-242, 2000. ##

[12]. Ma X., Sakanishi K. and Mochida I. “Hydrodesulfurization reactivities of various sulfur compounds in diesel fuel,” Industrial and engineering chemistry research, Vol. 33, No. 2, pp. 218-222, 1994. ##

[13]. Otsuki S., Nonaka T., Takashima N., Qian W., Ishihara A., Imai T. and Kabe T., “Oxidative desulfurization of light gas oil and vacuum gas oil by oxidation and solvent extraction,” Energy and Fuels, Vol. 14, No. 6, pp. 1232-1239, 2000. ##

[14]. Qiu L., Cheng Y., Yang C., Zeng G., Long Z., Wei S., Zhaoa K. and Luoa L., “Oxidative desulfurization of dibenzothiophene using a catalyst of molybdenum supported on modified medicinal stone,” Rsc Advances, Vol. 6, No. 21, pp. 1736-1745, 2016. ##

[15]. Qian E. W., “Development of novel nonhydrogenation desulfurization process & mdash; oxidative desulfurization of distillate and mdash,” Journal of the Japan Petroleum Institute, Vol. 51, No.1, pp. 14-31, 2008. ##

[16]. Yang C., Zhao K., Cheng Y., Zeng G., Zhang M., Shao J. and Lu L., “Catalytic oxidative desulfurization of BT and DBT from n-octane using cyclohexanone peroxide and catalyst of molybdenum supported on 4A molecular sieve,” Separation and Purification Technology, Vol. 163, pp. 153-161, 2016. ##

[17]. Bradley S. A., Broach R. W., Mezza T. M., Prabhakar S. and Sinkler W. “Zeolite characterization. zeolites in industrial separation and catalysis,” Wiley-VCH Verlag GmbH and Co. KGaA, pp. 85-171, 2010. ##

[18]. Elaiopoulos K., Perraki T. and Grigoropoulou E., “Mineralogical study and porosimetry measurements of zeolites from Scaloma area, Thrace, Greece,” Microporous and Mesoporous Materials, Vol. 112, No. 1-3, pp. 441-449, 2008. ##

[19]. Elaiopoulos K., Perraki T. and Grigoropoulou E. “Monitoring the effect of hydrothermal treatments on the structure of a natural zeolite through a combined XRD, FTIR, XRF, SEM and N2-porosimetry analysis,” Microporous and Mesoporous Materials, Vol. 134, No. 1-3, pp. 29-43, 2010. ##

[20]. Ates A. “Role of modification of natural zeolite in removal of manganese from aqueous solutions,” Powder Technol., Vol. 2, No. 64, pp. 86-95, 2014. ##

[21]. Garcia-Basabe Y., Rodriguez-Iznaga I., de Menorval L. C., Llewellyn P., Maurin G., Lewis D. W., Binions R., Autie M. and Ruiz-Salvador A. R., “Step-wise dealumination of natural clinoptilolite: Structural and physicochemical characterization,” Microporous and Mesoporous Materials, Vol. 135, No.1-3, pp. 187-196, 2010. ##

[22]. Wei X, Smirniotis PG. “Development and characterization of mesoporosity in ZSM-12 by desilication,” Microporous and Mesoporous Materials, Vol. 97, No. 1-3, pp. 97-106, 2016. ##

[23]. Ates A. and Hardacre C., “The effect of various treatment conditions on natural zeolites: Ion exchange, acidic, thermal and steam treatments,” J. Colloid Interface Sci., Vol. 372, No. 1, pp. 130-40, 2012. ##